1. Simple operation, repair the dent in quickly.
2. Paint less repairing car dent body, does not damage the original paint.
3. Different sizes of traction tabs, which has used for the different size of dent.
4. Application: Car surface pits repair
Material:Plastic & Stainless Steel
Size: As shown
1. Clean the dent with a clean wet cloth
2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and
preheat for 5 minutes
3. Use a proper drawing gasket. Large dent requires a large drawing gasket.
4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue)
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres
(Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter)
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen
8. Clean the repaired place with a clean wet cloth.
1 X Lift Active Tripod Puller
1 X Pull Hammer
1 X Copper Head Glue Gun
1 X Repair Hammer
1 X Small Red T Puller
1 X Bridge
1 X Adhesive Shovel
1 X Tap Down (with heads)
2 X Head
6 X Glue Stick
5 X Repair Pen
23 X Glue Tab
Product ID: 1114421